00TransMegaLinkDon
First, we see the whole system.
We design and deploy antenna systems for sites where connectivity must remain predictable — before installation, during commissioning, and after handover.
- Design
- Installation
- Support
00TransMegaLinkDon
We design and deploy antenna systems for sites where connectivity must remain predictable — before installation, during commissioning, and after handover.
01Survey
Terrain, interference, connection points, and site constraints are documented before the specification is formed.
02Engineering
We connect coverage calculations, the RF path, power, and redundancy in one architecture, avoiding incompatible decisions at system boundaries.
03Deployment
The installation team follows a prepared plan. After configuration, we take control measurements and record actual parameters.
04Handover and support
We hand over documentation, a clear view of every node, and a support plan. The infrastructure can be maintained and extended without starting again.
Full cycle
01—04One accountable team
We do not pass problems between vendors, designers, and installers. Every decision stays connected from initial site data to on-site measurements.
We collect site data, identify constraints, and establish the project’s engineering baseline.
We connect equipment, the RF path, power, and redundancy in one coordinated specification.
We deploy to plan, configure every node, and verify actual communication parameters.
We hand over a recorded configuration and remain available for service and upgrades.
A working configuration, verified parameters, and documentation your team can use to maintain the system.
Consultation
Describe the task in a few lines. Your request, selected service, and contact details will go directly to an engineer in Telegram.